thinbluebbq & others,
––Here’s the “link” to the “scans” of the I-94 decals.
––I-94 Enterprises doesn’t have EVERY decal scheme in the world, but they have very many that you can use for painting your A&A units. I not only RECOMMEND them, but I seriously suggest you look at the “SCANS” of the actual decals before ordering so that you’ll know exactly what you’re getting. I’d say these decals are cost-effective and will make your units look soo much SHARPER in their detail versus hand-painting, but that’s just MHO. So far I’ve already bought about $350 worth and I have a ways to go to get to everything detaild/painted. The pics Lucas showed above should be very helpful.
P.S.-Here are some “Risk Factories” that “Allworkandnoclay” has just completed with the aid of some
You guys might want to check these sites out. Or just scroll up above this post.
I found it.
This link has everything you need. I will be using the black 30 mm stand with peg and micro magnets from the above link.
I think for global 40 sets will suffice, possibly 50. Need micro magnets for all the planes ( about 80-90) and 40 for the stands.
I am combining the resources for making these bases.
This site has the proper magnets. Still looking for metal rods that are pre-cut about 2 inches.
A friend of mine has the most perfect examples. Here is what he did ( reprinted from email).
I bought the magnets from K&J Magnetics… They were almost the smallest available size with a hole in the center to fit a 1/16" rod.
I drilled holes in pennies, glued 1/16 inch brass rod into them, placed the magnet on top and glued it down.
http://www.kjmagnetics.com/proddetail.asp?prod=RC22 ( this link has the base with 1/8 OD hole)
Is a link where YOU personally link the instructional!
Somewhere in the customizations section a guy made a whole tutorial, with downloadable PDF’s.
Hey all, new to the Axis and Allies forums and to customizing my ships. I apologize if this was answered elsewhere, but how do I size these carrier decals down to fit my ships? They look much bigger, and I’m assuming I need to arrange them onto a photoshopped page of some sort?
As a side note, i’m curious if anyone has made country symbols on a handy one piece sheet with all the countries included so that I can print out one set and decal up my whole set of models. I’m not sure if they have them in a 6mm size, or 8mm size etc.
If not I might have to try this on my own, but I didn’t want to recreate work someone else has already done.
I couldn’t find any magnets that thin. I just redid mine yesterday and had to use thicker ones. Good job Sired.
I don’t know if they have Home Depot in Canada, but that’s where I got it, if not, you can find it here :
It has bad reviews lol, but it works good, just don’t stick to anything. However the drop of super glue seems to work, as they have never fell off.
Thanks for the comment cyanight, all your magnetic mods are pretty amazing!
We do have Home Depot (all over the place here), but they don’t seem to carry Magnetic Tape.,… well, they do, but it’s this stuff : https://www.homedepot.ca/en/home/p.12-x-10-magnetic-tape.1000418120.html?autoSuggest=pip which wouldn’t work as it’s a LOT thicker.
I HAVE however seen that stuff at Micheals Arts and Crafts. You’re right, it doesn’t stick well (or at all) so superglue is a must.