Sub question

Yes sir ^^  and thanks for the answer

@Fighter:

Whatever fleet you build as UK, you are free to place in the seazones around UK. Then on the german players turn, he has 2 options: stay and fight against whatever fleet you might have built, or to run away.

This is correct. You may put new naval units in a zone that still contains enemy units.

What I used to do, as a high school girl, was to use a white chip under the control marker to signify it made it past the end of the chart once.

Now a days, I use a mapping utility even for face to face games.  No limit on pieces, on chips or on money!  (Also it’s set up instantly and you don’t have to put it away when you’re too drunk to see straight!)

Yes to all.

Thank you good sir.

In basic A & A, you must unload all troops from a TR on the same territory, & once the troops are offloaded, the TRs movement ends. You CAN p/u troops from different locations (say load one INF in Phillipines, move TR to Okinawa, load another INF at Okinawa, move to Sea Of Japan SZ, unload both INF in Manchuria), but they all must be unloaded on the same territory (in the example, the 2 INF could be unloaded on either Manchuria or Japan Home Islands but not one on each).

In any case where a unit is involved in combat on Combat Phase, that unit’s move ends & it may not move again on Non-Combat Movement. The only exceptions are FTRs & BMRs which may fly out on Combat Move, be part of a battle in Combat, then fly back on Non-Combat Movement.

It’s possible I’m wrong about the landing of units on 2 land territories adjacent to the same body of water as the TR, but if I am, the rule is logical, & intuitive & I would recommend using it anyway…

Ozone27

American, first lanuage! :)

Thanks for the help.