It’s not perfect, but it has the same level of detail as a regular axis and allies piece considering it’s size. I’m not sure I will need help designing anymore. I figured it out for myself.[0_1603832941634_Type 59 (1).stl](Uploading 100%)
Thanks, will give that try. The other/combined issue is that it is so pliable that the plastic bends and the paint peels off also. Might even try a dip in super glue or something.
Hello! I saw that you may be interested in purchasing Axis and Allies minis. If you are interested, I literally own every set & every miniature that exists. Message me if you are interested. Everything I have collected of A&A has been kept in special protective cases, preserving everything in an absolute state of flawlessness. Message me if you have any questions as well. Thx!
I was thinking of doing this myself. I was going to place a magnet under the carriers in the void space and then superglue a ferrous metal wire to the underside of the planes. Has anyone tried this. Is it not enough to make the planes stick?
Ive never tried it but I think it will work. You will need those 3mm hobby magnets, not sure if they are Rare Earth or not. They do an excellent job at holding tank turrets in place so its not a stretch to think they will work in your application.
8 Hand ground shells, made from brass.
My own resin cast fuel cans and spare tracks.
Metal barrel with 3-piece heat-shrink tubing muzzle break.
Paper utility racks on each side of superstructure.
Spade shovel made from paper and brass.
Flat-nosed shovel.
Antannae made from fine brass wire.
Radio.
2 crew.
Folded-down rear gate.
Tarp.
Tent roll.