Well the data base is almost complete for units, you just need to start spaming other sites.
If we get enough players, I’ll put a tounament together.
Hey folks just wondering if anyone else has thought of this.
I have been thinking of introducing Reinforcements during game play. Heres what I’m thinking.
Maybe have the window for reinforcements be turns 3-4-5 on a roll of 6 you can bring them in at turn 3 if you don’t get the roll try nxt turn roll 4-5-6 and it’s auto at turn 5. I’m thinking 25 - 35 points. I think the points are not enough to tip the balance in a slaughter but may have a good effect on some close ones. Still mulling this over. I remember playing some old Avlon Hill war games early 80’s (before cards and pieces) and am pretty sure they had reinforcements in there.
It does sound like a good idea. I know there are times I wished I could have thrown a few more troops into the battle.
Ya if I play a large scenario we use renforcements!
How do you guys do it? Is it anything like I spelled out. What are the drawbacks ? (if there are any)
For my huge battles reinforcements are usually a must - it’s too much to have everything on the board at once - Normandy, Kursk, Battle of the Bulge, and the upcoming Pacific Island battle are all using waves of reinforcements. You can do it without reinforcements of course, but if you do the turns can take forever. In smaller games unless its part of a scenario (hold out until the Shermans arrive, etc) I don’t use them.
How much the waves are depends on a few things - do we want it to be a tug-of-war where sides alternate between having the ‘strongest’ forces, or just one extra wave, or multiple ones.
For example our Normandy game had the Allied landing forces 3:1 to the Wehrmacht forces defending the beach, and their Paratroopers/Resistance forces were around 1:1. However the landing forces came in waves every other turn until they were all used up, and the Germans got a huge reinforcement but it was split up into 3 groups and each had to roll a certain number before it could come on (D6 + Turn Number > 8 I think it was).
In Kursk both sides had reinforcements on set turns, and only a fraction of the German force began on the map; every 2 turns another wave came on (Recon, Panzers, then support weapons). The Russians also had reinforcements come on when the Germans got their largest wave.
Battle of the Bulge was pretty simple; both sides recieved reinforcements turn 5.
In our Pacific Battle tonight the Japanese get no reinforcements, and the US land in higgins/amtracks/sherman DDs - they get 6 reserve higgins in case the others are destroyed. The US has a set amount of forces; if they run out then too bad. After a Higgins drop off troops the US side can remove it and move on a new loaded one next round, so the arrival of the waves is determined by the players to a degree (if they want to take a direct route, or go around the side of the island).
OK, Thanks for the advice it helps a lot. I knew it had to be used just wasn’t sure how to go about it.
I’ve used reinforcements before, but mine were much more simple. My opponent and I would build our starting army, at say, 250 points. Then on let’s say, turn 3 or 4, we would deploy our reinforcements, valued at about 150 points.