Custom 3D Miniatures: Major & Minor Industrial Complexes, Recruitment Center, Airbase, and Naval Base

Or maybe noting zombie kills per nation and for every X number of kills tech is achieved.

@vodot Sir, this is brilliant! I always though the Dutch East Indies looked ugly on that map. So with these overlays, not only does it look so much better, there’s more territories for more strategies! Also, this fixes my biggest problem with 50th: Italy. Italy originally only had three territories, and was overall irrelevant to the game as a whole. But here, There’s more territories for them, and a new pair of frontlines with IEA. Australia is improved too, which is a welcome quality-of-life addition.

@LebaneseWarlord said in Need advice for custom dice DIY:

I’ve recently bought 96 dice because I wanted to make custom hit/miss dice for Global 40. I bought these dice from amazon and they’re plain blank and white dice.

I don’t have a lot of experience with DIY projects but I have access to a lot of good tools so I’m looking for advice regarding techniques on how to mark and repaint the dice I bought.

For the marking, I was thinking about using a rotary tool to carve a little dot.

The real challenge is the painting. I looked a lot on internet and I can’t seem to find a technique for painting on plastic that everyone agrees on, but here’s what I have so far.

Wash the dice to remove any grease that could be on the surface Use very fine sandpaper or some sort of abrasive to remove the protective finish that is on the dice right now and offer a better surface for the new paint to stick Wash the dice again the remove the dust from the paint removal Apply one or a few (I’m not sure about this one, I’ll read what is suggested on the can) of primer Apply a few thin layer of the color I want on the dice Paint a white dot in the carving I made earlier with a fine brush Apply one or a few (not sure about this one either, something will be suggested on the can) of clear finish to protect the paint

Any correction or suggestion would be very welcome!

Guys use RIT dye for color. Go to Siredblood’s custom dice you tube video. Shows how he used a jig to spot hole dice and then dye them

@655321
If you read this thread you’d fine that the short version of my verdict on the game was:

So you’re in good company here. Most of the haters are over on the G40 board.

Thanks Dauvio. I appreciate it.

No Trenacker. Just get a white primer and don’t forget to put on some sort of clear coat after to protect them.

The best approach I’ve seen was a friend who cut his factories in half with a hacksaw. Large factories are majors, while the smaller, halved factories are minors.

I’ve got mine painted three different colors. Bought a lot of 50 for a few dollars from a vendor at Nashcon in May 2016.

Before Nashcon, I used red Monopoly hotels for the major factories and the green hotels for minor factories. I still like to use the green ones every now and again because I think they’re nifty.

this first pic is what i had been using, i manually printed things out in one page sections via “print selection” command and pieced them all together, and laminated them with clear packing tape. Ultimately it proved to be a little larger than the default gameboard like I wanted, but still sloppy looking and with some bumps here and there which complicated unit placement due to tipping or sliding:

it was larger enough than the default board that things in europe didn’t seem so crowded anymore, but shoddy looking still, and that can wear on the nerves.

So I finally said enough is enough, and took the map pdf file on a jump drive down to minuteman press in London Kentucky and had them blow it up and laminate it….it costed $118 IPCs U.S. Dollars.

Its 2 foot by 3 foot, and gives us plenty of room for stacks. I got tired of kenny’s fat fingers knocking over my german stacks and scattering them across europe…he says my money was wasted because “those damn germans were going across europe anyway I just helped you out is all”.

but here it is: