Custom carriers from OOB's and painted pieces

@LebaneseWarlord said in Need advice for custom dice DIY:

I’ve recently bought 96 dice because I wanted to make custom hit/miss dice for Global 40. I bought these dice from amazon and they’re plain blank and white dice.

I don’t have a lot of experience with DIY projects but I have access to a lot of good tools so I’m looking for advice regarding techniques on how to mark and repaint the dice I bought.

For the marking, I was thinking about using a rotary tool to carve a little dot.

The real challenge is the painting. I looked a lot on internet and I can’t seem to find a technique for painting on plastic that everyone agrees on, but here’s what I have so far.

Wash the dice to remove any grease that could be on the surface Use very fine sandpaper or some sort of abrasive to remove the protective finish that is on the dice right now and offer a better surface for the new paint to stick Wash the dice again the remove the dust from the paint removal Apply one or a few (I’m not sure about this one, I’ll read what is suggested on the can) of primer Apply a few thin layer of the color I want on the dice Paint a white dot in the carving I made earlier with a fine brush Apply one or a few (not sure about this one either, something will be suggested on the can) of clear finish to protect the paint

Any correction or suggestion would be very welcome!

Guys use RIT dye for color. Go to Siredblood’s custom dice you tube video. Shows how he used a jig to spot hole dice and then dye them

Greetings,
Did you ever finish your map?
If so, can you share with community?
I am in process of selecting a map to print, and yours embodies much of what I am looking for in a map.

Hi,

yeah, i’ve seen that…i just wanted to make them myself :)

it goes very well with my terrain board…

I have seen lots of people here use acrylics and I have on occasion. Most of my paints are enamels though. I find that is stays wet longer (which is a good thing) and doesn’t clump up nearly as much on your brush. I also use enamels in my airbrush. I find that enamels are actually much easier to clean than acrylics. While acrylics are water soluble, they don’t just dissolve, especially if already dry. It involves a great deal of scrubbing and scraping. With enamels, all you need is some mineral spirits cleaner and it takes the paint right off with very little effort. Cleaning acrylic paint out of my airbrush was hell the first time I did it… never using acrylics in there again. In terms of the finish, I can only assume that enamels hold up better to bumps and scrapes than acrylic paint does.

Someone once asked if enamels, by default, have a glossy finish to them. They do not, as long as you are using flat enamels, which seem to be the standard. I use flats and they have an excellent, non-shiny finish. I feel like enamel colors are a little deeper too, on the whole, but I suppose it depends on the brand of acrylic you use. Vallejo seems to be a popular choice for acrylics. I use predominantly Model Masters (Testors) enamels. In general, I would just said to find a brand you like to work with and produces the results you like. Don’t buy super cheap paint… you will get the results you pay for.

Good luck!

Hmm interesting cynight…. I recieved 4 hurricane fighters with my set… Is that standard with the order?  Thanks for the boiling water method I will try that this weekend and hopefully be Painting some units this weekend :)

@Intrepid:

/how’s that for my 3rd and 4th posts ever, haha! Been a member of this forum since 2007, but I’m the ultimate lurker (mostly because I know I’m too easily tempted to get long-winded!)

You have exercised an extreme amount of restraint posting 4 times in almost 10 years. Glad you chimed in here.

Dedo… sounds awesome, you’re a legend.  :-D